Tektronix P6032 10Mohms to 50 ohms 850MHz Cathode-Follower probe

Description

The
Tektronix P6032
is an 850 MHz cathode-follower probe, intended for use with samplers such as the
1S1
,
3S1
,
3S76
and
4S1
.
There is an
EC1000
subminiature triode in the probe body, which is why it gets slightly warm during operation.
Like all active probes, the P6032 requires power, and for this reason it has two connectors at the scope end of cable. There is a four-pin power connector and a 50
Ω
GR-874 connector
for the signal.
The triode has limited dynamic range, so attenuator attachments are provided that attach to the tip of the probe. These attenuators also reduce the loading of the probe on the probed circuit.
Display picture is shown on a
545A
with a 1S1 and P6032 probe.  Pulse is generated by Tek
284
tunnel diode pulser driving into 50 ohm load, GR-BNC adaptor and then to the probe using a probe to BNC adaptor.  The 10x attenuator tip was used on the P6032 probe for testing.  The  timebase is 200ps/div.  Photo courtesy of TekWiki.
NOTE: Unit will be double boxed.
------------------------------------------------------------------------------------------------------------------
Payment Policy:
We accept PayPal (via Ebay)
Shipping:
USA:  We use UPS Ground as standard shipping method for all 48 States.  Ebay GSP is used for limited international shipping.  See below.
International Shipping:
LIMITED INTERNATIONAL SHIPPING
INCLUDES
:
Canada, United Kingdom, Denmark, Finland, Greece, Japan, Sweden, Belgium,
France, Ireland, Netherlands, Spain, Italy, Germany, Austria, Israel,
Mexico, Switzerland, Norway, Bermuda, South Korea, Taiwan
Returns Policy:
Our goal is to ensure you are completely satisfied with your purchase. Please
Read carefully the description of the item listed for full details before bidding.
No returns or exchanges are accepted.
-------------------------------------------------------------------------------------------------------------------